Ernesto Sanchez wrote:

Ernesto Sanchez wrote:

snip Paul said:

How many can handle just a raw casting?

I would like a semi finished one.  All I have is a drill press and a die
grinder but if that is not posible I'll take a raw intake manifold and a

set

of injector holders.
Ernesto

I'll let you know the cost of the machining Ernesto. Jerry has a mill
if he will loan it to you. How far are you from Jerry's place?
Paul Lamar

About the same to Santa Paula....120 miles north.
Ernesto

Well then you can drive down to my place on your day off and 
do half a dozen :)

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.