snip Paul said:

How many can handle just a raw casting?

I would like a semi finished one.  All I have is a drill press and a

die grinder but if that is not posible I'll take a raw intake manifold and a
set of injector holders.

Ernesto

I'll let you know the cost of the machining Ernesto. Jerry has a mill

if he will loan it to you. How far are you from Jerry's place?> > > Paul
Lamar

About the same to Santa Paula....120 miles north.
Ernesto

Well then you can drive down to my place on your day off and do half a

dozen :)

Paul Lamar

Sounds good to me! It's always fun to visit you. I'm off Tuesdays,
Wednesdays.
Ernesto

OK you can stay overnight in the apartment if you wish.
I'll let you know when we are ready. I need to design a fixture
to hold the intake runners so the injector bosses can be machined.
Can you fab from sketches?

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.