I got the parts. How many people on here have a good
auto body grinder? Three to five HP?
Here are a couple of shots.
Paul Lamar
-Finn Lassen wrote:
Big burning question:
Weight as is?
Finn
I don't know yet. Have not had one on the scale. I need another 300 pound scale for the
office. My guess is 4.5 pounds raw and an easy one pound out with a hack saw
for a 13B engine prior to 93. More if you want to have at it with a body
or die grinder. The injector holders/bell mouths weigh 11 oz for the small
and 14 oz for the large. Both will lose a few ounces when finished.
The Mazda injectors are three ounces each in case you are wondering.
A typical pipe bend might weigh about 7 or 8 ounces. Half that if you go with
high buck, thinner wall tubing.
What does your current three carb set up weigh?
Paul Lamar
An old list shows them at 5 pounds.
Finn
Well you will probably wind up with more than five pounds but you will have
more HP than your current three carb set up and less fuel burn. You are close to 200 MPH
now so you should pick up a few MPH and a lot better climb. How's your prop?
Under pitched or over pitched?
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2002 All world wide rights reserved.