Subject: ceramic coating on exhaust pipes
From: ACRE NL
Date: 1/28/2003, 6:54 AM


"Brian D. Cain" wrote:

I've been thinking about this as well for both exhaust and intake
purposes.
One company I've run across (per a VHS video I saw once) is Jet Hot
Coating
in CA http://www.jet-hot.com/ -- They may be worth checking out.

B


Doug Mueller wrote:

Hi Brian, I am familiar with Jet Hot. It is not a process that they have
that
makes them unique. If you read their ads, they claim they have been
doing it the
longest. I agree with them. The original company is in Phoenix,Arizona.
Their
materials come from the same supplier in California.

"Brian D. Cain" wrote:

Thanks, Doug.  The real reason I was considering such an avenue to take and
research on a couple of cars here was on the outside of the lower intake
manifold;
this thing heat-soaks to no end with a large stove of a turbocharger sitting
merely
inches away from it as well as a smoldering hot, cast iron exhaust manifold.
One
thing I've noticed is no matter how cold the charge temperatures are at the
point
of entering the throttle body/upper intake manifold, the temps have to rise
rapidly
right back up again from the ambient temperatures heat-soaking the lower
manifold from the exhaust components just below.

Something to think about ...

Brian D. Cain -/- Grand Prairie, TX -/- bdc196@attbi.com

That is interesting Brian. I wonder how much turbo heat we are transferring to
the charge in an aircraft installation. We pump a lot more air on average.
I'll have to place my intake air temp sensor down near the rotor housing.
Might be worth putting a bit of insulation between the turbo and the intake
manifold.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.