Subject: It fits -drilling the mounting holes.
From: ACRE NL
Date: 2/5/2003, 10:14 AM

I know most of you know how to do these things but just in
case. I learned this Lexan template trick from the  metal shop guys
at TWA repairing Lockheed 1011 fuselage cracks.

You could use a gasket as a template but that is not very accurate.
Best to get some 1/8" thick Lexan at the hard ware store and use your
old manifold as a template. Lexan machines without cracking unlike 
Plexiglas.  Cut the Lexan to size and tape to the back flat side
of the manifold. 

Use a box cutter and a steel straight edge to mark the tops and sides
of all four intake holes so you can line the template up exactly
with the new manifold intake holes. No need to cut out the intake
holes in the Lexan.

Place the Lexan flat on the bench with the manifold on top. 
Use a transfer punch to mark the exact center of all the mounting 
holes.

Separate the two and drill the Lexan template with a small drill.
Say 1/8 inch or smaller. 

Tape the template to the back of the manifold. Be careful to get
it oriented right as the hole pattern is not symmetrical. Offer
the template up to the engine to check for front and back.

Drill all the mounting hole positions  in the new manifold from the back side
using the small drill. Un-tape the template and turn it over. Use a center 
drill on each small hole to make sure the bigger bolt size drill does not wander. 

Now drill all the mounting holes from the front side. You are finished
drilling the mounting holes. You can counter bore the center hole to reduce 
the required length of the center mounting bolt if you wish. Be careful 
you don't break through the center intake runner walls.

More latter on trimming the flange.

Paul Lamar
  
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.