Got the manifold on today. Wonder of wonder it

clears the stock turbo,

I had them all faced off both top and back.  You

will have to cut off

part of the flange and drill the mounting holes

depending on the year

of your engine. More about that soon.

I am ready to ship the manifold.
Price for the manifold alone is $160 plus $15

shipping in the lower

48. Overseas, Alaska and Hawaii  depends.

Send a check for $175 if you want one to:

Paul Lamar
830 East Santa Maria St.
Suite 303
Santa Paula Calif.
93060

Price will go up later when we go into general

distribution.

Still need to do some machining on
the injector holder runners. Ernesto if you could

come next week we

can finish those off. More about that shortly.

Paul Lamar

The check is in the mail, how much for the

injector holders.

Bill Schertz
KIS Cruiser #4045

Don't know yet but they will be fairly cheap. Around
$39 each.

Btw for the Cruiser where space is tight above the
engine I recommend
sawing off 3/8 of an inch all away across the top.
That is there to accommodate
93 and later engines that have the ports moved up.
If you don't have
a capable band saw let me know and we will work
something out.

Use two inch inside radii RB Wagner thick wall 1-1/2
inch pipe bends.
That is a center line radius of slightly less than
three inches.

The RB Wagner cost for bends is half tubing bend
prices
and there is no need to heat treat. If I get a lot
of interest we can
do a group buy on RB Wagner bends and save even more
money.

I know you know all this but I am reminding the new
people.

Here is a picture that shows the excess material
above the left top mounting bolt.

Paul Lamar

Paul, Any left? If so I'll send a check> Thanks Jim coffman

Thank you Jim.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.