> > > Got the manifold on today. Wonder of wonder it
     > > clears the stock turbo,
     > > >
     > > > I had them all faced off both top and back. You
     > > will have to cut off
     > > > part of the flange and drill the mounting holes
     > > depending on the year
     > > > of your engine. More about that soon.
     > > >
     > > > I am ready to ship the manifold.
     > > > Price for the manifold alone is $160 plus $15
     > > shipping in the lower
     > > > 48. Overseas, Alaska and Hawaii depends.
     > > >
     > > > Send a check for $175 if you want one to:
     > > >
     > > > Paul Lamar
     > > > 830 East Santa Maria St.
     > > > Suite 303
     > > > Santa Paula Calif.
     > > > 93060
     > > >
     > > > Price will go up later when we go into general
     > > distribution.
     > > >
     > > > Still need to do some machining on
     > > > the injector holder runners. Ernesto if you could
     > > come next week we
     > > > can finish those off. More about that shortly.
     > > >
     > > > Paul Lamar

     > > > The check is in the mail, how much for the
     > > injector holders.
     > > >
     > > > Bill Schertz
     > > > KIS Cruiser #4045

     > > Don't know yet but they will be fairly cheap. Around
     > > $39 each.
     > >
     > > Btw for the Cruiser where space is tight above the
     > > engine I recommend
     > > sawing off 3/8 of an inch all away across the top.
     > > That is there to accommodate
     > > 93 and later engines that have the ports moved up.
     > > If you don't have
     > > a capable band saw let me know and we will work
     > > something out.
     > >
     > > Use two inch inside radii RB Wagner thick wall 1-1/2
     > > inch pipe bends.
     > > That is a center line radius of slightly less than
     > > three inches.
     > >
     > > The RB Wagner cost for bends is half tubing bend
     > > prices
     > > and there is no need to heat treat. If I get a lot
     > > of interest we can
     > > do a group buy on RB Wagner bends and save even more
     > > money.
     > >
     > > I know you know all this but I am reminding the new
     > > people.
     > >
     > > Here is a picture that shows the excess material
     > > above the left top mounting bolt.
     > >
     > > Paul Lamar

     > Paul, Any left? If so I'll send a check> Thanks Jim coffman

     Thank you Jim.

     Paul Lamar

bob mayer wrote:

Paul, I am interrested in one   if  still available. Check will be sent if so, Thanks, Bob Mayer.

OK Bob thanks.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.