This scan shows the effect of different pipe lengths
at 2000 RPM. IMHO this system is tuned for about
1000 to 1500 RPM one bounce. The 3'4" pipe is a bit too long
for a two bounce 2000 RPM system.
Same goes for the 1'7" pipe for a three bounce
system.
As I said the sum of the negative and positive areas is
the main factor controlling the additional HP generated.
Too bad they did not vary the pipe length is smaller
increments.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2002 All world wide rights reserved.