Jerry Hey wrote:
Paul, the tube marked with duct tape is intended to transfer bending
loads imposed by the engine mount back to the heavy cluster that is
the strongest point in the TW fuselage. The two cross tubes that
are circled (one fuselage and one eng. mt) would have flanges that
are bolted together. That point is where the two lower engine mount
tubes ( red lines) tie in. What do you think? Jerry
That will work fine Jerry. The tubing walls need not be any greater
than .035 as the loads are very low.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2002 All world wide rights reserved.