Rino wrote:
Hi Paul,
What is a good way to plug the the two primary injector holes in the
center housing.
I do not want any fuel on the hot side of the engine.
I think Tracy mentionned how to do that once but I forgot.
Rino
C-FZNW
Find a large pipe tap about the right size and tap it for a pipe plug.
The holes are about 11/16 th. Another way is machine a couple of
aluminum plugs and hammer or press fit them in.
The cast iron rib between the plugs can be drilled and taped
with a 10-32 screw to hold a retaining clip.
Stuff some paper in the ports and fill the holes with JB Weld :)
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2002 All world wide rights reserved.