Paul, will there be enough on the short side to put it in a 1/4" deep
counterbore in the manifold?
Is this material something we can TIG to the manifold?
..Chrissi

Sure plenty long enough. Well you can tig weld it or you can use glue
and small set screws if your going to counter bore it a 1/4 inch deep.
Me on the other will only counter bore just a tiny bit. Just enough
to locate the pipe and then tig weld. Can be done on a drill press
with a hole cutter.

OK, we'll go for it too, as well as a set of injector pipes
...Chrissi

The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.