Subject: Failure modes- - - detonation
From: ACRE NL
Date: 2/20/2003, 8:50 PM

wmd wrote:

I spoke to a friend the other day who does a fair amount of road racing and
he rruns an engine shop. He likes the rotary for its power and size but is
critical of it in that it is susceptible to detonation, which if it occurs
damages the seals and ruins the engine---not to the point of catastrophic
failure but  a reduction in power immediately and further over time.
What steps can be taken to prevent this in an aircraft engine application ?
Has anyone experienced this problem.

Comments ?

bill

Only the turbo is affected by this problem. The NA engine rarely detonates.
With the turbo use 3 mm Hurley Engineering  two piece steel apex seals. 
The 2 mm  three piece cast iron seals were developed by Mazda to improve 
the low RPM/low HP fuel consumption and emission problem. They have no 
benefits at high RPM and high power in a turbo engine. The two piece 
steel apex seals are much more rugged and less prone to fracture
under detonation.
 
Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.