> > Rino wrote:
> > >
> > > Hi Paul,
> > >
> > > What is a good way to plug the the two primary injector holes in the
> > > center housing.
> > > I do not want any fuel on the hot side of the engine.
> > > I think Tracy mentionned how to do that once but I forgot.
> > >
> > > Rino
> > > C-FZNW
> > Find a large pipe tap about the right size and tap it for a pipe plug.
> > The holes are about 11/16 th. Another way is machine a couple of
> > aluminum plugs and hammer or press fit them in.
> > The cast iron rib between the plugs can be drilled and taped
> > with a 10-32 screw to hold a retaining clip.
> >
> > Stuff some paper in the ports and fill the holes with JB Weld :)
> >
> > Paul Lamar
> Is there a way to run the pipe tap in and still remove the shavings without
> disassembing the engine?
Stuff the holes with rags and use a magnet to get the shavings out from the
top. Also light a candle and pour the hot wax in the hole forming a plug
in the bottom.
Paul Lamar
Fill the flutes of the tap with grease to hold the chips in the tap.
Mark Curley
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2002 All world wide rights reserved.