Jerry Hey wrote:
I do a lot of inside polishing in the 1.25" to 1.75" range. I have a
Sunnen SNJ-10 portable hone that will produce a mirror finish but is
no good for cleaning up welds, gouges and so on. For that I have
two 12 inch extensions one for the die grinder and one for the
electric drill. The one on the die grinder mounts various stones
with 1/4" shafts and the one on the electric drill mounts a piece of
aluminum oxide paper (also called a "shop roll") that acts like a
flapper wheel. It gets a lot of work done in a hurry and leaves a
beautiful finish. First the die grinder and then finish with the
sand paper. This combination is used to hone the inside of the 12
inch long gear leg sockets which have a lot of welding scale inside.
I also use the little "shop rolls" described by Paul and have found
the best way to mount them is to braze a sheet metal screw on to a
1/4" shaft that can be mounted in the die grinder. Be sure to turn
the air way down and run the die grinder at a relatively slow speed
or you will tear out of the shop rolls long before they are worn out.
Expensive and highly irritating.
Jerry
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2002 All world wide rights reserved.