Subject: Polishing your intake runners.
From: ACRE NL
Date: 2/20/2003, 9:52 AM


Since Paul Yaw claims intake runner air velocity is everything
polish your manifold and intake runners with this tool. Works
great chucked in a die grinder.

It is called a "Cartridge Roll". Made by 3M You will go through
a BUNCH. Comes in various grits. Rutland Tool. 800 289 4787
B&R Supply charges less. 805 656 0715

Or you could send it out and have it extrude honed after it was welded
up.  http://www.extrudehone.com/

Paul Lamar

Here is another opinion on Extrude Hone.
http://www.shotimes.com/SHO4extrudehone.html

Paul Lamar


"Brian D. Cain" wrote:

I'm a firm believer in this stuff (both Extrude Honing and polishing
intake plumbing).  One of the side projects I do for the street and
race Rx7 guys is a porting and polishing job on their throttle
bodies (couple photos here at http://bdc.genxracing.com/throttlebody).
I've learned that focusing on intake charge velocity produces
a much wider and higher power band vs. the old "bigger is better"
idea.

The picture you've posted looks like an aluminum oxide sanding roll
of some sort on a 1/4" arbor; I prefer using the Dremel in these cases
as the Dremel (even though using an 1/8" collet and having less
bits and accessories available) has far less torque and less ability to
"dance" off to the side somewhere while grinding and sanding.  I use
some gadgets that can be found at http://www.widgetsupply.com .

The best results I've found are leaving "wet" (with fuel) intake plumbing
walls at 120 grit unpolished (intake port tunnels on the engine itself)
and then the rest (dry) as mirror finished (polished) as possible.  Makes
a substantial difference and very highly recommended.

B

Brian D. Cain -/- Grand Prairie, TX -/- bdc196@attbi.com

The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.