Subject: Polishing your intake runners.
From: ACRE NL
Date: 2/20/2003, 8:13 PM

Archie wrote:

All port modifications should be done prior to any extrude honing.
Remember: Extrude honing continuously removes the high spots,
and enlarges the port depending on grit, pressure, and duration.
It will not remove metal from predetermined areas, or create "D"
exhaust ports. The finish can be beautiful, and increased in size, but
in some cases, as I have seen on my bench, it can also be detrimental
when overdone. Flowing the whole system will indicate this.
Just be careful, If a little is good, a lot may be bad.
Archie

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.