Michael McGee wrote:
The exhaust tuning discussion. This applies primarily to the NA folks
We have been going round about what is the best configuration for our
application. Two pipes into the muffler or one? Collector at 16" or
32". How long the collector? Personally I am looking to be one of the
quietest airplanes in the air with what I'm building without sacrificing a
lot of power.
In the Q&A session several people were interested in this since racers in
general now have noise restrictions. Apparently in Canada they are even
stricter than the US. Rob Golden stressed that having a dyno to help dial
in a muffler and exhaust system really helps. He likes to emphasize that
you can theorize all day but a test will show the proof. One test is worth
a thousand expert opinions and harder to get. I'll be able to do exhaust
tests with the engine test stand I'm building. At least to the static rpm
I'll be able to get with fixed pitch props. Paul and the gang might be
able to add it to the test regime they will be doing with the LAEV Prop.
The exhaust system needs to be tuned all the way to the end. It's
important to keep the pulse trains working together without fighting each
other. Primaries need to be matching lengths in exhaust pulse
wavelengths. Once the primaries are collected your wave length is 1/2 of
what it is in the primaries because the two are 180 out of phase. So your
collector length is dependent on half the primary wave length.
Primaries at one wavelength produce best power but make it peaky. Two wave
lengths help flatten the power band. For you 2.17 guys that sounds like
about 31-32", us 2.85 folks a little shorter. I wouldn't go any shorter
than 16" on the collector (two collected wavelengths).
Pipe diameter--this was interesting.
According to Rob Golden, if you are putting out 275 hp (on a 13B) then a 2"
primary pipe is the about the right size. It keeps the flow velocities in
check and still keeps the pulse trains well defined. For less than 275 hp
scale the area of the pipe down accordingly. This puts my 200hp target
with pipes that are:
200/275 = (pri dia)^2/(2")^2 ...(I've already canceled the pi's and dia/2)
pri dia = ~1.7"
Loosen up a bit and call it 1.75" ID
Collector diameter = sqrt[2*(1.7^2)] = 2.4" ID,
using 1.75" pri, you get a 2.5"ID collector
Comments on these numbers anyone? It all sounds plausible to me.
MGM
Mike McGee, RV-4 N996RV, O320-E2G, Hillsboro, OR
13B in gestation mode
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2002 All world wide rights reserved.