$50 each plus $15 shipping for up to four at a time.
Lots more machining on these than on the manifold.
Sorry about the bad pics. My camera had sanding dust
on the lens :) will fit both Mazda (Nippon Denso)
and Lucus injectors. Also I think Bosch but I am not
sure because I don't have one.

Send checks to me at:


830 East Santa Maria St.
Suite #303 <<<<<< very important.
Santa Paula CA
93060

Paul Lamar

Paul,
  I am using a custom built crossover intake with six individual intake
runners on my 3-rotor.  If you have six (three of each size) left, I will
take them for my 20B.  I will put a check in the mail in the morning.  I'll
up the shipping to cover the two extra pieces.
Thanks,
Mark S.

I still have runners. BTW if you are using six runners I suspect two 13B  manifolds
will also work. You cut one down to only two runners. Four plus two is six duh! :)
You can weld them together. Use the right half of the second manifold.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.