Hi Paul and Robin,
Well the state of progress is that the airframe is complete and
painted without any go fast stripes, after completion and some hour's
up I will apply any changes.
I have attached some photos of progress.
The engine will go in this week so I can complete the cooling and all
associated duct work and cowls.


--
Best regards,
 ddunbar                          mailto:ddunbar@echidna.id.au

Looking good Don. If that does not look like your average Mustang II
it is because Don built a female mold and laid up a carbon fiber roof with
gull wing doors. Is that a stock smog pump I see on the right
side of the engine for the vacuum instruments Don?

Paul Lamar

       Don and Paul,

          If I were a betting man I would say that is a water pump instead
  of a smog pump! IMHO

       Kelly Troyer

My subconscious knew there was something wrong with that picture
but it did not surface :) I would make a lousy witness. :)

What is the reason for the side water pump Don?

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.