Hi Paul and Robin,
Well the state of progress is that the airframe is complete and
painted without any go fast stripes, after completion and some hour's
up I will apply any changes.
I have attached some photos of progress.
The engine will go in this week so I can complete the cooling and all
associated duct work and cowls.


--
Best regards,
 ddunbar                          mailto:ddunbar@echidna.id.au

AN> Looking good Don. If that does not look like your average Mustang II
AN> it is because Don built a female mold and laid up a carbon fiber roof with
AN> gull wing doors. Is that a stock smog pump I see on the right
AN> side of the engine for the vacuum instruments Don?

AN> Paul Lamar

Paul that is the water pump on the right, The pump is a self contained
Toyota pump that delivers about 20% more than the stock N.B..
It is also much lighter and puts the pump down low allowing maw to put
a header tank high on the firewall. The original pump would have had
no head and any loss of water would of had it sucking air.

--
Best regards,
 ddunbar                            mailto:ddunbar@echidna.id.au

The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.