$50 each plus $15 shipping for up to four at a time.
Lots more machining on these than on the manifold.
Sorry about the bad pics. My camera had sanding dust
on the lens :) will fit both Mazda (Nippon Denso)
and Lucus injectors. Also I think Bosch but I am not
sure because I don't have one.

Send checks to me at:


830 East Santa Maria St.
Suite #303 <<<<<< very important.
Santa Paula CA
93060

Paul Lamar

Paul,
  I am using a custom built crossover intake with six individual

intake

runners on my 3-rotor.  If you have six (three of each size) left, I

will

take them for my 20B.  I will put a check in the mail in the morning.

I'll

up the shipping to cover the two extra pieces.
Thanks,
Mark S.

I still have runners. BTW if you are using six runners I suspect two 13B
 manifolds
will also work. You cut one down to only two runners. Four plus two is
six duh! :)
You can weld them together. Use the right half of the second manifold.

Paul Lamar

Got that part finished. Weight of flange and six tubes is 4lbs, 1 oz.  It hugs
the top of the engine and leaves lots of room for a turbo.  The intake runners
will get all the injectors & fuel lines away from the hot exhaust.  Speaking
for myself, that alone is worth the price.

Check was ready for the mail, but a freak ice storm has Austin, TX shut down,
including the U.S. Mail service.  The check will go out tomorrow.
Mark S.

The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.