Racing Beat has a nice oil cooler by-pass block for use with a
remote
mounted oil filter; except it doesn't apply to 3rd generation, or
20B
engines, where the oil return goes into the block beneath the
filter.
I'm going to have a similar block made that will have the 16mm port
(I
think that's what it is) and also include a port for oil feed to
the
re-drive. If anyone else needs one of these we can make a few when
we
have the setup and save some $.
I just used a 3/4 inch thick block of aluminum and cut holes for the
oil passages and bolts. I
then tapped the oil passages with a npt thread and presto, remote oil
filter block. I then took
the oil filter mount and threaded the oil passage holes for NPT thread
and, with the addition of
oil lines I have a remote oil filter setup, and for minimum $.
Brian Trubee
Brian - Great idea. I had looked at that when you mentioned it some
time back. However; I decided I wanted the filter between the outlet
and the cooler; and a larger, full-flow filter (actually I'm using a
dual-filter remote mount from Earls, same one Racing Beat sells).
As I understand the way that stock setup is that one of the two outlet
ports is what has gone through the filter, and goes to the oil gallery,
and the other port feeds back to the passage to the oil pressure control
valve and to the pan. So flow can bypass the filter back to the sump.
I don't really think that's an issue ; but . . .
What size line and fittings are you using?
Al
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2002 All world wide rights reserved.