Racing Beat has a nice oil cooler by-pass block for use with a remote

mounted oil filter; except it doesn't apply to 3rd generation, or 20B
engines, where the oil return goes into the block beneath the filter.

I'm going to have a similar block made that will have the 16mm port

(I

think that's what it is) and also include a port for oil feed to the
re-drive.  If anyone else needs one of these we can make a few when

we

have the setup and save some $.

I just used a 3/4 inch thick block of aluminum and cut holes for the oil

passages and bolts. I

then tapped the oil passages with a npt thread and presto, remote oil

filter block. I then took

the oil filter mount and threaded the oil passage holes for NPT thread

and, with the addition of

oil lines I have a remote oil filter setup, and for minimum $.

Brian Trubee

kevin lane wrote:

I need one for my 20B too.  Make one for me please.  Kevin Lane  Portland OR

The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.