Snip

Here is a rendering of the channels of the proposed water neck.
Both the inlet and the outlet are brought out with 1 3/8 ID channels.
This casting could also incorporate a motor mount.
Another advantage to Don's idea is no need to cut down the stock
Mazda water pump to get it under a low cowl. the water neck can
be as  low as the end housing.

Comments anyone?

Paul Lamar

Michael McGee wrote:

Looks like a good start.
Make sure it does not interfere with the crank angle sensor housing for
those of us using this.
I'm using an old front housing that already has a motor mount.

Mike McGee, RV-4 N996RV, O320-E2G, Hillsboro, OR
13B in gestation mode

Good point Mike. I forgot about that. Looks like I need to come stright
out on the right side. The water inlet side.

Hold on I'll fix it. 

.....

.....

OK here it is along with what the casting will look like.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.