Russell Kent wrote:
Paul Lamar wrote:
Here is a rendering of the channels of the proposed water neck.
Both the inlet and the outlet are brought out with 1 3/8 ID channels.
This casting could also incorporate a motor mount.
Another advantage to Don's idea is no need to cut down the stock
Mazda water pump to get it under a low cowl. the water neck can
be as low as the end housing.
Comments anyone?
Unless there is some great payback that isn't obvious (to me at least), I'd avoid putting a
motor mount on the water pump simply because it makes it that much harder to make the water
pump housing light, and it needlessly complicates the task of servicing the water pump
(should it fail).
Russell Kent
The motor mount will not be on the water pump. It will be on the water neck.
The water pump itself will be mounted down along side the cool part of the
engine below the alternator.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2002 All world wide rights reserved.