ddunbar wrote:

Hello Paul, Kelly and others,
I will fabricate by welding hose necks the the mount plate or tap in
fitting's depending what I can find.
I have been looking at al types of hoses and fitting's for the cooling
system.

The mount was made from angle 6061 T6 4"x3"x3/8.
The attached photo has the rubber mount in place and the inlet and out
let will inside of this.

I will attempt to find out what engine this pump is of.
It was a 4 cylinder turbo engine that had the pump down low on the
right side in the same position as I have installed it.
The pump is also mounted to the same angle as above and I will weld or
tape fitting's to suite the hoses I decide to use.

--
Best regards,
 ddunbar                          mailto:ddunbar@echidna.id.au

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.