Subject: another pic - perry2 results
From: ACRE NL
Date: 2/25/2003, 5:48 PM


Dan Ruggirello wrote:

I should have sent this pic along with the others.  This overall
velocity plot of perry2
shows the
high pressure in front of the inlet causing boundary layer separation
problems.  If there
was
no oil cooler to obstruct the flow through the duct, I don't think
you would see this
problem.
Wait a minute, that's the answer - remove the oil cooler!  ;-)

I forgot to ask about the space above the inlet between the inlet and
the strake.  How is
this
configured?  I ran two cases - one where flow is assumed to be
unobstructed to simulate a
faired
3D surface where flow would slip around it and another where flow was
not allowed to pass
through.  The latter case is worse for boundary layer separation.

Dan

Dan:


Thanks for doing all this, it is interesting.  To answer your question,
there is a one inch
thick leading edge airfoil shape between the oil cooler inlet duct and
the bottom of the
strake. If you were looking upward through the duct and it was
transparent or downward
through the strake and it was transparent that is what you would see.

I took some pressure measurements with an airspeed indicator some time
ago, before my most
recent mods.  It showed pressure on the inlet was lower than at the
exit!  This did not make
sense to me but I'm sure it was accurate: later I made the inlet bigger
and cooling got
worse!  I think I originally had reverse flow and making the inlet
bigger made the flow
stop.  Then I did some things to try to get flow out the exit so things
would be working as
they should in the right direction. Your simulations seem to show that
even though it is a
big snoot 5 x 5 inlet the air really just wants to go around it.

Perry


I agree Perry. That could be for one of two reasons. A. The scoop is not
far
enough down to be out of the boundary layer. B. the pressure is too high
on the back side of the oil cooler reflecting through the cooler all
the way forward to the scoop entrance.

Paul Lamar

-Dan Ruggirello wrote:

No problem.  Just want to contribute to the group however I can. And I am
learning a bunch about cooling issues too.

It is curious having a low inlet pressure.  The attached pic shows a
decreasing pressure towards the inlet....... but pressures still greater
than the exit.   I am inclined to believe the problem lies in too high an
exit pressure as Paul said.  Does the duct have its own exit, or does it
dump into the pressurized engine compartment?

Dan

That one is real strange Dan. Too bad the weather is so bad. I would take
my water manometer up and help Perry measure some pressures. Perry,
how about a RS232 module data acq system. Do you have a note book computer?
Do you have a digital camera to take some pictures of the water manometer
mounted in the back seat over your shoulder? I can ship you
the water manometer and a bunch of tubing.

Paul Lamar

The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.