Dan Ruggirello wrote:
I should have sent this pic along with the others. This overall velocity plot of perry2 shows the
high pressure in front of the inlet causing boundary layer separation problems. If there was
no oil cooler to obstruct the flow through the duct, I don't think you would see this problem.
Wait a minute, that's the answer - remove the oil cooler! ;-)
I forgot to ask about the space above the inlet between the inlet and the strake. How is this
configured? I ran two cases - one where flow is assumed to be unobstructed to simulate a faired
3D surface where flow would slip around it and another where flow was not allowed to pass
through. The latter case is worse for boundary layer separation.
Dan
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2002 All world wide rights reserved.