Dan Ruggirello wrote:
Here are some results..............when animated, you can see the low
pressure eddy's from BL separation continuously rolling into the duct,
then
dissipating. It appears that this run has full on BL separation. I
probably should allow one of the other sims to run longer to verify if
they
too would have full on BL separtion.
Hmmmmm........inlet pressures through the duct seems lower than other
runs.
Dan
Dan; just a couple of comments on this one. The idea is to have the
scoop entrance just aft of the bump compressing the boundary layer; so
shortening the scoop entrance can help in more ways than one. Less
separation and high pressure turbulence.
The exit fairing is the right idea - lowest drag is a faring that looks
like the top have of an airfoil - but in this case the exit area should
be decreased to further accelerate the exiting air and to cause less
turbulence on top.
Al
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2002 All world wide rights reserved.