join?
[Unable to display image]
[Unable to display image]
Dyke Delta JD-2
Lawrence O. La Beau
EAA# 421587
Las Cruces, NM
N207LL
The first of July 1996 I bought a set of plans for Dyke Delta S/N 1419 from
designer John Dyke. The 29th of July 1996 I purchased the first materials to
construct N207LL. Construction continued until Feb 2002 when I pulled it as a
trailer on its main gear (part of the design) 600 miles from San Antonio,
Texas, to Las Cruces, New Mexico at 65 mph. From Apr 2002 to Feb 2003
construction continued in Las Cruces until the final inspection 1 Feb 03 and
airworthiness certificate dated 7 Feb 03. In Texas and New Mexico I licensed
it as a trailer with some, "you can't do that" threats, unbelief, and help by
fellow EAA members. I'm planning for first flight before the end of February
03. It is also registered with the State of New Mexico.
Changes are a fuel
injected Mazda 13B with 2.17 gear reduction and a three bladed electric
adjustable Magnum composite prop. Ignition and fuel injection is controlled
by a dual programmable computer system. Mixture is changed by a knob and
indicated using O2 sensors and LED readouts of air/fuel ratios.
I used G-10
fiberglass .047 x 4' x 8' sheets for the skins, gas spring to assist gear
retraction, stainless steel wing rib caps and bracing, and an internal
aluminum fuel tank. Performance is expected to be about the same as with an
O-360 Lycoming. The Mazda runs very smooth compared to four banger's and
makes static RPM.
This is my first finished homebuilt. In 1965 I recovered a
Mooney Mite and flew it around the Seattle area before selling it. I started
a Davis DA-3 in 1972 and sold the airframe, could not afford to buy an
engine. In 1992 bought a 1964 Mooney D with retractable gear and no PC. Flew
it to Alaska and above the artic circle and back to San Antonio in 58 hours.
Fairbanks at the end of June was 95 degrees for two days without the humidity
of San Antonio.
***********************************************************************************
Thanks Tom. Sounds like Tracy's EFI system and a Ross or Tracy's gear box.
The pics did not come across
When one sees a picture on a web site one wants to capture, one can right click
the mouse button, scroll down and choose "Save As". Choose a folder on their
hard disk and save the picture. It should be a gif or jpg. Then one
can email them to us.
There is certain html code on certain web sites that
don't allow this. If that is the case on the EAA web site more evidence
they are not worth joining.
I might pop over there and interview him. Perhaps Chuck Dunlap could
do it for us as he is half way there from here. Do you have a digital
camera Chuck? Heck a cheap card board box camera would work.
Send me the cardboard camera and I'll pop for
picture development. Kelly, do you have his email address?
If I had known about it I would have stopped in on the way to S&F
last year in the 182. Not planning on going by 182 this year.
BTW it will be interesting to see how that IVO Magnum prop works :)
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2002 All world wide rights reserved.