Jerry Hey wrote:
Paul, I am ready to install the radiator. The louvers are
operational. I am going to use a duct that opens underneath the
prop. The opening will be 12 x 4 (48 sq inches) connecting to the
intake plenum by a 10 inch long duct. Not bell shaped but opening up
an inch in both planes. Would a bell shape using those numbers flow
better than straight sides? The opening at front end of the
radiator would be 13 x 5 (65 sq inches). From there the plenum is a
wedge shape, 18 inches long, five inches high tapering to ????? Your
recommendation please....... In order to fit the wedge plenum, I will
have to reshape the oil pan. When I built it, we were still angling
the rad down front to back. No big deal. I can now say for sure that
all this stuff is going to fit in a hole designed for a Lycoming.
Jerry
Constant area duct leading to a straight sided wedge on top of the rad.
Tapering to a sharp edge at the back of the rad. As in this rendering.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2002 All world wide rights reserved.