Jerry Hey wrote:

Here are a few photos showing progress to date.   This is pretty close
to the final position but the back end will have to lifted about  1/4
inch to be exactly level.  The louvers in the photo are open to 35
degrees but  I can open them to 70 degrees if necessary.  That would
entail welding extensions on the side pieces which I now want to do
anyway for cosmetic reasons.   No problem as they are .063 6061.
Operation of the louvers is silky smooth.

Jerry, When you send these from a Mac make sure they have the .jpg file
extension. One was too dark.

O.K.  I just switched from Graphic Converter (easy) to PhotoShop (not
so easy).  I will educate myself before sending any more photos.
Jerry

The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.