Jerry Hey wrote:
Just a heads up Paul. As soon as I get the actual corner locations, I
will forward the information to you for an engine mount drawing: 20B
turbo in a Murphy Super Rebel. If this engine is placed so that the
prop flange location (of the Lyc. 540) is retained, there will be
plenty of room in front of the firewall to X the lower tubes if that
is what you decide to do. That seems like a good solution for sheet
metal aircraft and is easier for me since I do not have to provide a
center bracket. I also will be building a MM for a BD4 (Bob White)
that I will want you to supply a drawing for. Again, I am waiting for
precise measurements. Eventually, you will have a portfolio of
rotary engine mount drawings covering most of experimental aviation.
Here is a note I sent to Barny tonight:
Barny, I have now seen enough to tell you that the proposed motor
mount will work very nicely in the Murphy Super Rebel. There are two
possible versions depending on whether or not we can attach the bottom
tubes to the firewall bottom center. If there is a strong point there
that we can attach to, we will use it. If not, then we can accomplish
the same thing by forming an X with the bottom tubes. The motor mount
will be clean, light and strong and will not conflict with the under
engine radiator or the turbo. The design is Paul's double triangle
beauty that he first designed for the Kiss Cruiser. I think you can
see a photo of it on the ACRE site.
Price: $1100.00 for the whole thing including the rear mount and the
Barry Isolators. A deposit of $550.00 with the balance due when the
mount is ready to ship. Jerry
OK Jerry.
Paul