Subject: Pineapple Racing Q&A- Coolant
From: ACRE NL
Date: 3/8/2003, 8:39 AM


This is a topic that has also generated traffic on the list in the
past.  Most people will use the ethylene glycol & water at somewhere
between 20/80 and 50/50 mixture.  The guys at Pineapple Racing are
pretty
opined that the best coolant to use is the Evans Cooling NPG+.  Of
course,
they also sell the stuff.

Looking deeper into this, when Pineapple Racing sends a street rod or
racing engine out the door it has Evans NPG+ in it.  I seem to
remember
(don't quote me on this) that if you have one of their engines your
warranty depends on using NPG+.  Their web sight has a good write up
on the
stuff with some interesting points.  Primarily for us airplane folk,
the
claim is you can run it with an un-pressurized system.  Without
regurgitating everything here, I'll point you to the web site.
http://www.pineappleracing.com/Prod-EvansNPG.html

The down side to Evans NPG+ is the price.  Without calling around, the
first price I found on the net was $89/4 gallon case.
http://www.dieselsitetoo.com/product.asp?0=207&1=220&3=42
You DO NOT cut this with water, it runs straight, so you use at least
twice
as much.  In fact according to Pineapple you need to flush with Siera
(propylene glycol) in order to absorb all the water after flushing out
the
EG if you're switching over.  At over a hundred bucks, an expensive
installation.

Everything is a sales pitch until you have tried it or seen it work.
The
guys at Pineapple Racing have enough credibility with me that I will
probably try it on the test stand and move it to the plane if
successful.  The benefit of having an atmospheric pressure cooling
system
goes without saying..if it works at half an atmosphere (18,000 feet).
I'll
be studying this some more.
http://www.evanscooling.com/

Comments?

Mike McGee, RV-4 N996RV, O320-E2G, Hillsboro, OR
13B in gestation mode


Without having a thermal couple located within 2 mm of the combustion
chamber adjacent to the lower spark plug (cyl head temp gage) I can not
say if NPG (propylene glycol) works or not. There are some theoretical
heat transfer problems with it as I recall.

We had a long discussion about it on here a few years ago. It may not
boil over but that does not necessarily mean it is cooling the metal
like it should.
Paul Lamar


When I looked at this option awhile back I concluded that we should not
(or at least be very cautious) about using the Evans coolant in our
application with the stock pump.  Yes; the lower vapor pressure and
higher boiling point are good things; BUT, it has a lower specific heat
and higher viscosity requiring higher flow rates and higher pumping
power for the same amount of cooling.  There is good reason that they
recommend using their pumps.

Al Gietzen

The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.