Subject: Pineapple Racing Q&A- Coolant
From: ACRE
Date: 3/10/2003, 8:03 PM


Mike McGee wrote:

 Continuation of topics from a tech Q&A session at Pineapple Racing in
 Portland, Oregon on Feb 22nd.  This is the last one, I hope the posts have
 been at the least interesting and maybe we learned something.

 This is a topic that has also generated traffic on the list in the
 past.  Most people will use the ethylene glycol & water at somewhere
 between 20/80 and 50/50 mixture.  The guys at Pineapple Racing are pretty
 opined that the best coolant to use is the Evans Cooling NPG+.  Of course,
 they also sell the stuff.

 Looking deeper into this, when Pineapple Racing sends a street rod or
 racing engine out the door it has Evans NPG+ in it.  I seem to remember
 (don't quote me on this) that if you have one of their engines your
 warranty depends on using NPG+.  Their web sight has a good write up on the
 stuff with some interesting points.  Primarily for us airplane folk, the
 claim is you can run it with an un-pressurized system.  Without
 regurgitating everything here, I'll point you to the web site.
 http://www.pineappleracing.com/Prod-EvansNPG.html

 The down side to Evans NPG+ is the price.  Without calling around, the
 first price I found on the net was $89/4 gallon case.
 http://www.dieselsitetoo.com/product.asp?0=207&1=220&3=42
 You DO NOT cut this with water, it runs straight, so you use at least twice
 as much.  In fact according to Pineapple you need to flush with Siera
 (propylene glycol) in order to absorb all the water after flushing out the
 EG if you're switching over.  At over a hundred bucks, an expensive
 installation.

 Everything is a sales pitch until you have tried it or seen it work.  The
 guys at Pineapple Racing have enough credibility with me that I will
 probably try it on the test stand and move it to the plane if
 successful.  The benefit of having an atmospheric pressure cooling system
 goes without saying..if it works at half an atmosphere (18,000 feet).  I'll
 be studying this some more.
 http://www.evanscooling.com/

 Comments?

 Mike McGee, RV-4 N996RV, O320-E2G, Hillsboro, OR
 13B in gestation mode


Without having a thermal couple located within 2 mm of the combustion
chamber adjacent to the lower spark plug (cyl head temp gage) I can not
say if NPG (propylene glycol) works or not. There are some theoretical
heat transfer problems with it as I recall.

We had a long discussion about it on here a few years ago. It may not
boil over but that does not necessarily mean it is cooling the metal
like it should.

Paul Lamar


  I have run Evans coolant for about 300 hrs but I am not sure if I am
going to stick with it as I am about to fill it up in a few days.
  Cost is one down side and the other is the availability when out on
the victor air ways if you need to top it off as you cant mix water
with it.
  The other brew I used was 60-Sierra 40-water mix that also worked fine.

  Ken Welter

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.