Subject: Turbo compound 20% less fuel burn.
From: ACRE
Date: 3/11/2003, 9:53 PM



 > Huh?  I assumed that there would be a step-down planetary between the
blow
 > down turbine and the ring gear mesh.  What am I not seeing?
 >
 > Russell

 6000 rpm on the 12 inch dia ring gear means the one inch starter pinion
 is really
 zinging along at about 72,000 RPM. That gives a mesh velocity of
 19,000 feet per minute which is too high. No way around this except
 to use a smaller ring gear. About 6.3 inches in diameter.

 Paul Lamar

I think Russel is refering to having the TC drive the ring gear that is part
of the PSRU. So the engine spline drives the sun gear, the TC drives the ring
gear in the PSRU and the power is taken out of the planet gears. Your ratio
changes depending on the relative driving of the ring and sun gears.  This is
what the Toyota prius does with the hybrid.

Bill Schertz
KIS Cruiser #4045

The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.