Subject: Turbo compound 20% less fuel burn.
From: ACRE
Date: 3/11/2003, 9:24 PM


Paul Lamar wrote:

Since I got this new pattern making capability I am thinking of
building a turbo compound gear box to hook to a ordinary
turbo charger. The way I figure it I will need a .32 inch
diameter pinion gear capable of 24 inch pounds of torque
at 120,000 RPM (50 HP) or a pitch line velocity of 10,000
feet per minute. I might need a planetary set up
to reduce the load on the small teeth.

That seems to be within the capabilities of gear makers.

The final drive could be a starter pinion on two or more
ring gears side by side. Pitch line velocity at 6000 RPM
with a 12 inch ring gear will be 19,000 feet per minute
which is pushing the envelope. Perhaps the starter pinion idea
won't work. I might have to go to a separate smaller diameter
gear on the nose of the E shaft.

The fluid coupling will be integrated with the gear box.

Check my math. Comments anyone?

0.32 inch seems pretty aggressive.

Why kill yourself to mesh with the engine rpm?  Drive the PSRU ring
gear and let the PSRU mix the engine and TC torque.

Russell Kent

That is what I originally planed but the ring gear pitch line velocity
appears
to be too high. 10,000 feet per minute appears to be the gear limit.

Paul Lamar

Russell Kent wrote:

Huh?  I assumed that there would be a step-down planetary between the
blow
down turbine and the ring gear mesh.  What am I not seeing?

Russell

6000 rpm on the 12 inch dia ring gear means the one inch starter pinion
is really
zinging along at about 72,000 RPM. That gives a mesh velocity of
19,000 feet per minute which is too high. No way around this except
to use a smaller ring gear. About 6.3 inches in diameter.

Paul Lamar

kevin lane wrote:

I was wondering if the turbo could also spin an alternator or generator
which could run an electric water pump, thus eliminating the gear drive
problems.  isn't the additional hp avail. about what is needed by the
alternator and water pump?  are there reasons an alternator wouldn't work at
high rpms?  would the high temps kill it?   kevin

To be worth while the turbine should provide about 20% more power
or about 40 HP. The water pump is about 3 HP and a 70 amp alternator
is about 980 watts output say 1200 watts mechanical input or about
1.6 HP to drive the alternator.

A 3 HP electric motor to drive a water pump would consume 2200 watts
or about 160 amps at 14 volts. You would need two alternators and the
mechanical to electric and electric back to mechanical conversion 
efficiency would be real bad. Down around 65%.!

Don't anybody ever bring up silly electric water pumps on here ever
again :)
It is about as silly as an electric car.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.