Subject: metric to A.N.
From: ACRE
Date: 3/11/2003, 8:15 AM


Wow!  Three very large Setrabs.  They would not be there if you did not
 > need them. Is there an outlet duct underneath the two on top?
 >
 >     Do you think that just matching the size of the stock oil cooler
 > will be adequate.  I have been feeling good about the claim that the
 > Setrabs will be  more efficient than the stock cooler.  What do you
 > think of this claim?    Jerry

The two on top of the radiator air box get pressurized ram air from below.
The layout is not ideal, and these two are cooling the scavenge loop, so they
got a bunch of air going through them. That makes them much less efficient.
The lower one is in the pressure loop and works very well on it's own,
because there is very little air mixed into the oil.

Matching cooler capacity by comparing cubic inches of volume is a step in the
right direction. However, notice that the stock cooler is souped up a bit to
perform as well as possible in a limited space. Notice that it is heavy. It
is deep front to back. The fins are very fine and very close together. They
are double pass. The inlet and outlet are on the same end. This makes for
easy hookup. It also makes for higher flow velocity through the tubes. A
natural film of chilled oil tends to cling to the inside of the tubes and
insulate the hotter oil from the tube. Same thing in water radiators. Higher
velocity tends to eliminate that film and keep cooler and hotter oil mixed
up. So, the double pass layout makes for double the velocity. The stock
cooler is that shape because of where it has to fit. Not because that is the
ideal shape for an oil cooler. Assuming the same air pressure on one side,
and the same frontal area, the Setrab may be no more efficient because of
less oil flow velocity and less mass. The fins allow higher air velocity but
there are fewer fins. The Setrab has the better shape
but would need just a bit more frontal area to perform as well. Since there
are installations working well with just the stock cooler I would say that at
speed, the shortcomings (close fin spacing) of the stock cooler are overcome
and it works fine. The race car doesn't spend much time above 100 MPH (it
frightens the driver) so more cooling capacity is required. The Setrab at the
same speed may be fine but I would start with a big one. You need to get rid
of about one-third of all of the waste heat
through it. Not over 200 water for a short time. Not over 225 on synthetic
oil for a short time. With a 31"X 19" Griffin we get 185 water and 190 oil at
full tilt. That to cool 245HP.
Your heat output may vary.

Lynn E. Hanover

Lynn has a minimum race car weight rule so he can afford weight
in one place and take it out someplace else. Some race race
cars need to add ballast to bring the car up to the minimum
rule weight. 

BTW IMHO if you are not adding ballast or structure 
on the floor the CG of your race car is too high and you are leaving 
cornering ability on the table. That is because the coefficient of
friction of rubber is inversely proportional to the load. Weight
transfer from inside tires to outside tires causes an overall average 
loss in coefficient of friction. My rule of race car design :)

The perfect race car CG height is .01 inches :) One of the few things 
the rules nazi cannot measure or check.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.