Subject: FUEL SYSTEM ONE WAY VALVES
From: ACRE
Date: 3/13/2003, 2:34 PM


 > > > > > Hi Yvon;
 > > > >
 > > > > In Fluid Control systems these are known as "Check Valves" their
 purpose
 > is to
 > > > > hold or prevent the fluid on reverse flow. In other words once the
 fluid
 > flows
 > > > > thru the valve it can not go back through it. So in order
to answer your
 > > > > question of whether they are necessary or not a sketch of your fuel
 system
 > > > > (schematic) is needed.
 > > > >                                                     Butch
 > >
 > >   I am currently working on my fuel system and the same thing crossed my
 mind
 > as the positive
 > > displacement pumps wont allow to backup through them I don't think they
 would
 > be needed.
 > >  I am running two pumps parallel with a pickup in the tank for each pump
 and
 > the pumps tee
 > > together into one line that goes to the carb.
 > >  Ken Welter
 >


********************************************************************************

 Hi Ken,......What type of pumps are these, obviously yours are low pressure
 since you're feeding a carburetor, how much pressure are they capable of
 developing?.....Are they piston, diaphragm, vane, gear?...where
are your check
 valves plumbed in.....are they in the two (2) suction
lines?.........Is there
 one on the tee'd outlet to the carb?
                                                        Butch


    I am using Bosch high psi injection pump and a bypass regulator to
cut it down to 4 psi.
  I have been running the check valves after the pump before the tee
or to be more specific I am using a Mallory regulator with a multiple
port manifold that I running the lines into.
  I cant blow through these pumps so I am going to try it without the valves.
   Ken Welter

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.