Bill, the new water pump is going into the foundry next week
so I will need that 8 inch pulley to test it with my 2 HP
mill motor. Do you still have it? Also any V belts you no
longer need. Refresh my brain on how you did the test.
Did you use a rad and a block?

Paul Lamar

Paul,
I'll ship you the pulley this weekend, won't be to the hanger until tomorrow
night.

I will do a short writeup of the testing and send it to you also, (need to
do it anyway).

Basically all my pump data has the 13-B block pressure drop included, since
thepump is mounted to the block.

Bill

I'll put it up on the web site. Safer place than my hard disk :)

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.