Subject: Turbo compound 20% less fuel burn.
From: ACRE
Date: 3/13/2003, 11:11 AM


Since I got this new pattern making capability I am thinking of
building a turbo compound gear box to hook to a ordinary
turbo charger. The way I figure it I will need a .32 inch
diameter pinion gear capable of 24 inch pounds of torque
at 120,000 RPM (50 HP) or a pitch line velocity of 10,000
feet per minute. I might need a planetary set up
to reduce the load on the small teeth.

That seems to be within the capabilities of gear makers.

The final drive could be a starter pinion on two or more
ring gears side by side. Pitch line velocity at 6000 RPM
with a 12 inch ring gear will be 19,000 feet per minute
which is pushing the envelope. Perhaps the starter pinion idea
won't work. I might have to go to a separate smaller diameter
gear on the nose of the E shaft.

The fluid coupling will be integrated with the gear box.

Check my math. Comments anyone?


Paul Lamar

Fred Osborn wrote:

Unfortunately, I deleted the reply that suggested taking
power off the turbo with a homopolar generator. I think that
came from Vance.

As a possible alternative consider a turbo driven
generator/alternator driving a form of an Integrated
Starter/Electrical Boost Motor coupled to either the output
or prop shaft ala hybrid auto. No gears and the loading on
the turbo could be optimized precisely by the electrical
interface control system.

The problem is alternators and electric motors are only about 80% efficient.
If you generate electricity and then use it to drive a motor that
then puts mechanical power back into the system you wind up with
something that is only .8 X .8 or 64% efficient. Hybrid cars
in city driving use the fact that a internal combustion engine is 
very very inefficient when running at low power levels. Say 35 HP 
out of a 200 HP engine. This is the case 98% of the time in the city. 
On the freeway at 85 MPH they are probably less efficient.

Hybrid cars are barely more efficient overall (city & highway) 
than the same chassis with a small internal combustion
engine yielding the same acceleration and more top speed
replacing the heavy  motor generator set/batteries. Not only 
that the car winds up with more usable internal volume. Expensive 
to make hybrid cars are merely a placebo to the wackos.

A small turbo compound engine would weigh much less and 
be less costly to make and would equal or exceed the fuel mileage
of a hybrid drive system. Particularly on the freeway.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.