Marc Wiese wrote:

Info on another psru. Don't know from this if it bolts up to the rotaries directly.



Marc Wiese

*********************************************************************

From: javlake@shaw.ca

From:Our Psru is built around the super duty Ford C6 panetary

gear.The

gears are helical cut,The bearings are angular ball

thrustbearings

45MM I.D.These bearings have been load tested at 21,700 lbs for
1000.000 revolutions.there are two of these bearings back to

back next

to the propflange.Another carrier bearing of the same size is

mounted

at other end of the propshaft. The propshaft is hollow.The harmonic

damper is part of the flywheel which works out very indeed! The whole
thing weigh's in at 42 lbs.price 2800 US Hoping this will answer your
questions for now

John Vlake. G.A.P. GearedAirPower industries . t George

Lendich
John,
Can you send some pics and other information? I am interested in
mounting it on a Mazda 20B 350 hp @4000 rpm 3 rotor rotary engine.
Whatratios are available, and does it have provisions for constant
speedprops (oil fed hub?). Do you have a website, etc?
Marc Wiese
Hello WieseSorry i do not have a website as yet.The only ratio we have is 2.17>:1.We are staying

away from     hydraulics, since" Ivoprop poduce" electrical controlled props, including constant
speed props up to 900 hp! There should   not be any problem to bolt one of my units on a rotary
engine . Hoping this will help you  along to your goal .    John Vlake    G.A.P.industries
oa                                                                                     &am p;nb
sp;

I like the bell housing :)

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.