Subject: LAEV Ready to Screw]
From: ACRE
Date: 3/18/2003, 7:14 AM


I tell you what, Paul,  I would be willing to take off my prop and
install
it for some test run ups.  Then assuming all looked well to everyone
involved (with me retaining veto rights {:>)) I could take it for a
gentle
flight to keep gyroscopic loads to a minimum.   And yes, I'd sign a
release.

Ed

Sounds good Ed. Keep the aerobatics down until we get a chance to
do the torture test. What do you think Butch and Perry?
With the variable pitch installed we can run it up on the ground to
6000 or more engine RPM.

Paul Lamar

Perry Mick wrote:

Due to a lack of a running engine on a sufficient test stand, that is
how I tested my fixed-pitch fans - bolt it on the airplane and hope it
doesn't fly apart!  Haven't had a failure yet fortunately.  If a blade
did depart don't know if I could get the engine killed fast enough to
prevent damage to the aircraft. In my case I was also worried about a
departing blade going through part of a wing or winglet. When I put a
new fan on my plane, I take the RPMs up very slowly in steps.

If Ed is willing to use his aircraft as a test bed it's fine with me, he
understands the risks. After you get the static RPM up, do several full
power runs down the runway before taking it off, also. You don't have to
build up a lot of speed since max thrust is at low speed.

--
Perry Mick
Custom Composite Props
mick@bridgingworlds.com
http://www.ductedfan.com

I think the runway test is also a good idea as there will be a bit of
pitch
bucking going on.

Also Ed while you are still home install a 1/4 inch or 3/8 inch engine
safety cable that will retain the engine in the event of a blade failure.
These are required on Reno racers and are a good idea in any event.

Paul Lamar


Yes, I agree with the suggestions, they are good ones, had also thought of
the "down the runway" tests.  I feel better about it being composite
blades - they seldom fail catastrophically  and they impose less gyroscopic
loads.
I'll find some of that plastic coated cable for the engine safety line and
figure out where to attach it.  Probably to the lower part of the engine
mount as there are 4 mounting bolts along the bottom and only two along the
top of the firewall.

  Perry, I appreciate your comments regarding your experience with testing on
the aircraft.  I have not heard from Butch as to whether he has/would have
the electrical connection mechanism (the plate with the conducting strips)
ready by then.

In any case, it will be great to see the LAEV assembled.

Ed


 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.