Subject: recovery tank
From: ACRE
Date: 3/18/2003, 11:12 PM


Jerry Hey wrote:

What wall thickness would be required for 4 x 8 x 12  (roughly one
gallon) aluminum tank with a 20 lb  cap?   An .050 wall 30 gallon
aluminum fuel tank with one baffle will blow up like a balloon with a
couple of lbs of air pressure.  Five lbs,  say good by.     Jerry

Hard to say. Rectangular containers don't do well
when pressurized.

Best to find something that looks as close to
a sphere as possible. Or make it out of large thin wall tubing.
One gallon is 232 cubic inches. A six inch OD tube
8 inches long is about a gallon.  A five inch tube one foot
long would also be about right.

Paul Lamar


O.K.   I just "ordered" a 6 inch by 8 inch piece of  irrigation pipe
that handles up to 100 psi in the field.  Sooner or later the farmer
runs over it with the tractor so it not hard to find a small piece. Can
the recovery tank be supplied from one of the  1/2" heater line ports
on the water pump?  Can I eliminate the swirl pot?  Could a low
pressure cap be used  initially on ground run ups to clear the
entrained air?     Jerry

Interesting idea Jerry. I don't know if that will work.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.