Subject: Building your own rotor housing grinder.2
From: ACRE
Date: 3/19/2003, 1:20 PM

In theory it is possible to build a rotor housing grinder out
of an old Mazda rotary engine. Here is how.

Use an e-shaft, one rotor and
one end housing with phasing gear. Mount the grinder on the rotor  so
the contact of the small grinding wheel is at one of the apex's of 
the rotor. Rotate the e-shaft and the grinding wheel will now trace
out the rotor housing curve.

You now need to figure out how to move the grinding
wheel up and down so the entire width of the rotor housing
can be re finished. All back lash must be removed from the phasing
gear and the rotor bearing clearance reduced to a minimum.
Perhaps by replacing the plain rotor bearing by pre loaded tapered roller
bearings. The phasing gear back lash can be removed by using
two rotor gears cut down to half width with a separating springs
attempting to rotate one relative to the other.

It might be possible to grind off the old chrome. I don't know.

This might be an economical approach for someone like Hayes
or Atkins that have large collections of junk rotor housings.

-- Paul Lamar The AirCraft Rotary Engine NewsLetter. Powered by Linux. ACRE NL web site. http://home.earthlink.net/~rotaryeng/ Copyright 1998-2002 All world wide rights reserved.