Subject: LAEV Ready to Screw
From: ACRE
Date: 3/19/2003, 5:57 PM


Russell Kent wrote:

Ed Anderson wrote:

Contacted Finn and he will lend me his chut should there be a flight
test of the
LAEV.

I have one thing to say regarding the testing of the LAEV on Ed's plane
before the
tilt-a-whirl torture test: how is this going to look in the NTSB
accident summary?

Russell Kent


Russel,

I for one, hope it says the pilot survived without injury {:>) and minor
damage to the aircraft.

 But, in all seriousness,  your point is well taken.  There is some hope
that we may be able to use Tracy's engine/stand mounted on a two wheel
trailer and by lifting the hitch as high as possible/practical and suddenly
lowering it to the ground cause some Gyroscopic loading on the prop.
Perfect? No, but then few of use have the $$ for what one might consider a
full-blown testing program.  I believe ground run ups, combined with high
speed taxi test down a bouncy runway and the trailer stand will reduce the
risk.

I am aware of several indivduals (without anyhwere near the experience of
Perry Mick) who have made composite prop blades and thus far I am unaware of
any failures.  The most serious failure mode, of course, is to lose a blade
or part of a blade.  Again, I am unaware of any composite prop loosing part
of a blade.  Not to say, it can't or hasn't happend, I am just not aware of
any failures in the composit structure of the blade.

I think the most likely blade  failure would be separation of the composite
blade from the metal journal it is attached to with resulting departure of
the blade. However, my recollection of the shape of that journel (like an
"S") means the composite material in the "S" bends would have to fail in
shear for the prop to be lost.  Now,  If this were a metal bladed prop then
I would be much more concerned about these types of possible failure modes.

I personally think the most likely problems we might encounter is binding of
the journels in the hub under load.  The hub will be attached to the engine
and restrained while the blade will be attempting to "cone" toward the front
under load.  This opposition of forces has to be resolved in the hub and the
prop blade journel and the hub is the common point.  Not being a mechanical
engineer I don't have a clue the magnitude of those forces, but would assume
they could possible cause the journel to bind in the hub.  That of course
would not necessarily result in loss of a blade.

My intended flight routine should not place great gyroscopic loads on the
prop, in fact, I will take care to insure they are minimal.  However,
whether we fly the prop or not, I think a ground runup would be useful.  If
any problems are discovered, they can be fixed before the full blow test
program..

Appreciate your comments

Ed Anderson


 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.