Dan Ruggirello wrote:
Paul,
Yes, I can apply as many loads as you want to the model. I'll go ahead and
place addional loads of 900 lbs +Y applied to each ear.....
I believe that a better alternative to the plate is the "ultimate housing"
though. I don't like the low stiffness characteristics of the overall
design of the plate. My concern is not stress, but the low frequency of the
plate/psru/prop.
I can also run a crude normal modes analysis of the plate with a lumped mass
representing the psru/prop and find say the first few modes. If you think
a normal modes analysis is worthwhile - can you give me a good weight for
the psru/prop, the approximate moment arm to the psru/prop cg? It would be
interesting to see how close the frequency is to 6500 RPM or so.
Dan
Ops forget to answer the questions.
My guess on the prop is 20 to 25 pounds. The complete PSRU is
about 45 pounds. Tracy's plate alone is about 8 pounds. The spacer
blocks and bolts... my guess is 3 to 4 pounds. There is an eight pound
starter bolted to it.
The big question is where is the CG for the remaining stuff?
Probably about half way out as the prop shaft and flange
is quite heavy. The overall length from 13B end housing to
prop flange is about 14.5 inches. The 1/2 inch plate is
3.05 inches from the end housing.
Here is a stiffer solution that I tried to talk people into.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2002 All world wide rights reserved.