Dan Ruggirello wrote:
Howdy Paul,
Couldn't resist getting this model going. Here are some results. I
constrained the 6 engine
mount locations in XYZ and applied a 360lb load in the Y direction 20
inches away. These results
are von-Mises stress. Max stress is really artificial since it is
where the nodes are
constrained and can generally be ignored for the plate. Max stress I
would estimate at about
16ksi, therefore, lots of low stressed material in this load case as
you can see.
Per MIL-HDBK-5, Ftu=42ksi and Fty=38ksi for 6061-T651 plate.
This model is really just a test to make sure it is working and it
looks good so far. Next step
could be to somehow constrain the ears appropriately. Hmmm.
Got any displacement data from the test?
Dan
That is just too COOL Dan!!! Looks like we should taper the ribs.
NEAT!!!
Thanks a bunch for doing this.
Jerry, do you remember how far it deflected when you put the 600 foot
pounds bending load on the motor plate?
Paul Lamar
Sorry Paul, I have searched my drives and cannot locate the test
results. I do have a folder which contains photographs of the test. I
will keep looking. Jerry
It was .065 as I recall.
Dan, please use .065 deflection at the end of two feet as the deflection angle.
opp/adj=tan theta or .065/24 or .16 degrees if my math is correct.
Can you use that to work backwards and calculate the max stress?
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2002 All world wide rights reserved.