Dan Ruggirello wrote:
I know what you mean about the Tab A and slot B. To be honest, I didn't
think about it. It is possible to model this. You could attach the faces
or edges that you assume are in contact and allow it to move in any
direction but the normal direction, or if a more accurate answer is desired,
you could use contact elements. Solution time goes up with contact elements
though because of the iteration involved. Let me know if you are interested
in more detail of the stresses on the ear. I would suggest a model of only
an ear with approriate boundary conditions and the 900 lb load. The 600
ft-lb load does not influence the ears with these boundary conditions.
I'll run the truss behind the plate next. Can you give me more detail how
you want that ran? (Loads, boundary conditons, output) Also, do you want
the plate modeled with the truss?
Dan
Or we could join them together as one piece and forget
the bolts. In the real design the bolts take no load.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2002 All world wide rights reserved.