William wrote:

William wrote:

Dan,
What information do you need to do an analysis on a different form of

motor

mount? I designed one using rectangular 4130 steel and bolting to the

oil

pan bolts.  I would be interested in seeing the analysis of this using

your

tool.

Bill Schertz
Kis Cruiser #4045

To save some time Bill. Dan will need dimensions of the tube and wall

thickness.

A dwg, IGES or DXF file would help.

Paul Lamar

Dan,
The "tape" was to hold the bolts down while putting the assemble together
before nuts were applied.

I have attached a DWG file. The cross bar is 1"x2" x 0.065" wall 4130 steel
tubing. The ends are 1/2" Aluminum (2024), and I use Barry mounts.

The hole through the bar is for the oil cooler, and has a 4130 steel tube
welded top and bottom, and then 1/8" plates on the front and back to make up
for the missing material.

Bill Schertz

Dan, let me know if you need this converted to an iges.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.